I am replacing the fuel gauge sending unit on our GT/CS and have a question on tightening the lock ring. I first hand tightened the lock ring in place. I then used a large screwdriver and hammer to further tighten (some pretty powerful blows).
The “ears” on the gas tank are only about ½ way up the “ramps” on the lock ring (see pictures). I am concerned that the ring could vibrate loose over time. I hesitate to tighten any more as I do not want to break the ears off the tank.
I am used to lock rings that tighten down and then “pop” in place and lock at the top of the "ramp". I have looked online for examples, and from what I have seen I think I am OK. Just don’t want to fill with gas and then leave it all on the street!
Thanks, Pat
The “ears” on the gas tank are only about ½ way up the “ramps” on the lock ring (see pictures). I am concerned that the ring could vibrate loose over time. I hesitate to tighten any more as I do not want to break the ears off the tank.
I am used to lock rings that tighten down and then “pop” in place and lock at the top of the "ramp". I have looked online for examples, and from what I have seen I think I am OK. Just don’t want to fill with gas and then leave it all on the street!
Thanks, Pat