CaliforniaSpecial.com -- Message Boards -- 1968 California Special Limited Edition Ford Mustang GT/CS
D I S C U S S I O N . F O R U M
COMMUNITY
1968 GT/CS & HCS
2007+ GT/CS
1966-1967 HCS

Vote!

Old 10/28/2017, 02:07 AM   #1
Jester
 
Jester's Avatar
 

Location: Southern Sweden
Joined: Jan 13
Posts: 99

My Garage
Remove and paint doors

I am going to remove the doors in order to paint the inside. Have never done this before and need a few pointers.

1: I assume best way is to unbolt the doors where the hinges bolts to the body of the car? Or can I get the pin out of the hinges? What is the easiest way?

2: the inside of the doors have a few spots of rust where the surface "texture" has been damaged. In other areas excessive paint has made the fine lines in the structure invisible. The paintshop suggested bead blasting, but it sounds like a bad idea to me as what is left of the texture will be gone forever. Suggestions?

3:is anyone sitting on photos or spec on the original divider line between interior and body paint?

4: Shall I expect alignment issues when I rebolt the doors?

Thank you!

1968 GT/CS Meadowlark Yellow C-Code
Jester is offline   Reply With Quote
Old 10/28/2017, 05:54 AM   #2
Ruppstang
 
Ruppstang's Avatar
 

Location: Weeping Water, NE.
Joined: May 09
Posts: 2,365

My Garage
I leave the hinge on the body. Be sure to mark the hinge position on the door with tape or a marker, that will eliminate a lot of the adjustment latter. Do not blast or sand the interior, you will loose the texture. Paint stripper and lacquer thinner work best with a scotch bright pad or course steel wool to scrub with. Be sure to mask any exterior paint to protect it. Wear gloves and eye protection! Not knowing how bad the rust is I can hope it is only surface rust that to can remove with navel jell or Evapo rust. Any welding repairs will be seen so I hope the rust is not too bad.
When you paint use only light coats that are just enough to cover. If you use too heavy of a coat it will be too glossy and fill the grain.

The paint line should be about 1 inch inside the weather stripping at the bottom of the door. You can find pictures of this at concoursmustang.com do a search for door interior paint under 67-68.

With the doors off I would take the opportunity to rebuild the hinge pins and bushings. I do it on the car.

Best of luck with your project.
Marty

Follow HCS restoration at http://68hcs.weebly.com
Ruppstang is offline   Reply With Quote
Old 10/28/2017, 07:29 PM   #3
rvrtrash
 
rvrtrash's Avatar
 
So many cars, so little time!

Location: Post Falls, Id.
Joined: Apr 03
Posts: 3,443

My Garage
I agree with everything Marty said, however, I have blasted the doors using glass beads instead of the aluminum oxide. It's softer and worked well for me, although I admit I was being pretty careful not to linger too long in any one spot.

Steve

The wannabe formerly known as an owner.
rvrtrash is offline   Reply With Quote
Reply

  CaliforniaSpecial.com Forums > GT/CS and HCS Forums > GT/CS and HCS Discussions

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
1968 - GT center cap red paint touch-up hatchdog GT/CS and HCS Discussions 14 09/05/2017 02:41 PM
At a cross road - any suggestions? Tequila Off Topic Lounge 14 06/10/2014 10:50 PM
Tail Light Bezel MArndt2001 GT/CS and HCS Discussions 15 04/15/2007 06:17 AM
Carwash 101 Mustanger Off Topic Lounge 3 09/28/2006 09:07 AM
Paint job questions luisa2552 GT/CS and HCS Discussions 2 11/21/2005 04:22 PM


All times are GMT -7. The time now is 02:25 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2017, vBulletin Solutions Inc.


This site created, owned and maintained by Jon Hanna - Copyright 1996-2011
All rights reserved. CaliforniaSpecial.com is not affiliated with Ford Motor Company

ShowCase vBulletin Plugins by Drive Thru Online, Inc.