I recently purchased a basket case gt/cs...... a previous thread i had mentioned missing parts for the radiator support well upon going through all the parts further the area where the vin stamping would be has been replaced, and the holes to bolt the fender to are missing due to the replacement. Also the cut out original vin stamped area is missing. I have recently seen a thread here where the vin stamping did not match the car, this is not a issue with this car as i have paperwork back to the original owner that purchased the car and all the tags, and the numbers matching motor. Or rather should i be worried this is missing, and what is the best way to go about taking care of this issue. LOL sorry for the long thread but this car originally was a heater delete car that was moved to Maine in the following years, and heat was later added any details on how the car would have been setup as a heater delete car are much appreciated. Thanks in advance for any support.