68Fan
Well-known member
I am replacing the rear valence on my CS and run into a gap problem. The valance I purchased is a remake from a reputable co. however it sits a bit off kilter when attached to the body. The right/passenger side valence to body gap is less than 1/4 in from top to bottom but the left/drivers side has a tight fit up top and a 1/2 in gap on bottom. There has been fender work done on the driver side but the original valence doesn't have nearly the same discrepancy.
Also, I have notice that some folks have opted not to install the rear bumper guards. Did the actual "GT's" not have them as a standard feature or is this just a preference? The new valence did not come with bottom rear bumper guard holes. Any information and/or opinions on this topic would be greatly appreciated.
Thanks in advance,
Sean (aka 68Fan)
Also, I have notice that some folks have opted not to install the rear bumper guards. Did the actual "GT's" not have them as a standard feature or is this just a preference? The new valence did not come with bottom rear bumper guard holes. Any information and/or opinions on this topic would be greatly appreciated.
Thanks in advance,
Sean (aka 68Fan)