CaliforniaSpecial.com -- Message Boards -- 1968 California Special Limited Edition Ford Mustang GT/CS
D I S C U S S I O N . F O R U M
COMMUNITY
1968 GT/CS & HCS
2007+ GT/CS
1966-1967 HCS

Vote!

Prev Previous Post   Next Post Next
Old 01/25/2014, 10:49 AM   #1
murf104
 

Joined: Feb 03
Posts: 272

Rocker panel molding clips (not) on front fender

While undergoing a repaint it became obvious that our CS, Scheduled build date of 4 - 03 had NO holes for a plastic rocker panel retaining clip on either front fender. The hole for the stud used in the front position on the moldings was there, just no place for the plastic clip that is shown in every Ford document that is at the rear of the front fender, just a bit in front of the junction with the front of the door. The fenders are dated to be correct for the car, there are no holes for the engine size badge which is consistent with CS manufacture. I am certain the fenders are original to the car and there is just no way that molding retainer could have ever been on the car, and both sides are the same. In your opinion is this something that Ford did on just the CS cars ? Evidence of this missing pair of holes in each fender show up on other CS cars - would you mind checking yours and see if there is a plastic clip in this position? I am curious if ALL CS cars have this clip omitted or just a certain batch manufactured in April of 68. Just curious about this little quirk. Also curious if this omission causes the molding to fit strangely or rattle or wear a spot in the paint. Thanks for any research you may provide.
murf104 is offline   Reply With Quote
 

  CaliforniaSpecial.com Forums > GT/CS and HCS Forums > GT/CS and HCS Discussions

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Front Fender Mustang Emblem Placement Perkchiro GT/CS and HCS Discussions 9 05/24/2005 06:58 PM
Rocker Molding Clips, again PB gtcs GT/CS and HCS Discussions 12 01/30/2005 03:07 PM
Rocker Panel Molding Clips case12 GT/CS and HCS Discussions 6 01/01/2005 01:05 PM


All times are GMT -7. The time now is 04:08 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2017, vBulletin Solutions Inc.


This site created, owned and maintained by Jon Hanna - Copyright 1996-2011
All rights reserved. CaliforniaSpecial.com is not affiliated with Ford Motor Company

ShowCase vBulletin Plugins by Drive Thru Online, Inc.