CaliforniaSpecial.com -- Message Boards -- 1968 California Special Limited Edition Ford Mustang GT/CS
D I S C U S S I O N . F O R U M
COMMUNITY
1968 GT/CS & HCS
2007+ GT/CS
1966-1967 HCS

Vote!

Old 01/24/2005, 08:19 AM   #1
PFSlim
My Car Details
 
PFSlim's Avatar
 

Location: Weatherby Lake, MO
Joined: Feb 04
eBay: calspec68
Posts: 1,546

My Garage
Stripe Experience

Folks

As you all know, we are new at this mustang restoration deal. Just as the good things we share, we must also share the bad things. Therefore, those who attempt to install their own GT/CS stripes, listen up!! :D

I ordered the kit from Steve (recommend by Paul N's book and by this site). The stripes were excellent. (this is where it becomes my fault). Next, we set a day to install stripes (yesterday) and our painter/body shop guy and myself began our work.

Now, I also need to explain that in the short amount of time of getting set up, we had visitors. Our mother, one of our wives, the guy who used to own the car, and a good friend of ours all dropped by to see the GT/CS and stripe installation in progress. (oh, and the family dog) ???

Now is the learning part. Never, Never, Never, Never, attempt to install stripes with that much going on. As well, peel the backing off the stripe, wet down the car with good soap water spray bottle, then attach stripe. DO NOT DIP the stripe with backing still installed into a bucket of water. This will only make the backing attach to the stripe and you can kiss that piece goodbye.

So, we did manage to only mess up on GT/CS piece and two door stripes. All other stripes are installed. >:( :( :'(

I made a call to Steve (stripe guy) late last night begging for another chance and he immediately said he would have those pieces sent to my house in a couple of days. A Great Guy!!! ;D

Anyway, just wanted to relay a bad experience. Nothing that money and time can't fix.

Paul
PFSlim is offline   Reply With Quote
Old 01/24/2005, 08:54 AM   #2
rvrtrash
 
rvrtrash's Avatar
 
So many cars, so little time!

Location: Post Falls, Id.
Joined: Apr 03
Posts: 3,437

My Garage
Re:Stripe Experience

Sorry to hear about the oops. In doing mine, I learned you should also use painters tape to set your line and stand way back to see what it looks like before taking the backing off. Thank goodness the body shop had lots of space when we did it. The GT/CS didn't look right unless it was tilted just a little bit because of the curves of the scoop, at least with YearOne's stripe kit. Good luck on round two.
Steve
rvrtrash is offline   Reply With Quote
Old 01/24/2005, 09:45 AM   #3
bbeatty
 

Joined: Apr 03
Posts: 143

Re:Stripe Experience

Ouch! Sorry to hear about the mishap :( but thanks for sharing your experence. ;D

Were you able to buy a partial kit or did you have to buy a another whole kit?
bbeatty is offline   Reply With Quote
Old 01/24/2005, 09:48 AM   #4
case12
 
case12's Avatar
 
'66 Convert., '00 GT Convert., '36 Ford, '07 Shelby GT-H Convt.

Location: Crystal Lake, IL
Joined: Oct 04
eBay: case12
Posts: 1,450

Re:Stripe Experience

Steve's comments have me wondering. When I stand back and look at my GT/CS, the portion on the scoop looks a bit crooked to the rest of the stripes. I have also seen this on some of the cars in the gallery and on the calendar. It somewhat depends on the angle you are looking at the car. Yet some cars look perfectly straight. Is this the way the stripe was put on the scoop, the way the scoop is mounted, or just how it is on some cars? Being a perfectionist, I dont like coming out to the car in the parking lot and thinking "man, that looks a little crooked". Any thoughts? Casey
case12 is offline   Reply With Quote
Old 01/24/2005, 10:14 AM   #5
PFSlim
My Car Details
 
PFSlim's Avatar
 

Location: Weatherby Lake, MO
Joined: Feb 04
eBay: calspec68
Posts: 1,546

My Garage
Re:Stripe Experience

Brian - we were able to buy a part kit, just the ones we needed. He is FedX'ing to us today and should be here tomorrow or next day latest.

Casey - It is difficult to get the scoop to match the stripe. In Steve's case, he had lots of room to really view the stripe as it flows into the scoop. We have that opportunity to view on passing side, but not drivers. Hopefully, ours will turn out okay but won't know until we put our door stripes on.

By the way, we used the measurements from Paul's book. Then used small pieces of tape to mark the front fender and door in front of scoop. Then, we used a red chalk line to snap a straight line. Next, we ran masking tape down chalk line to ensure the line was straight, wiped off chalk, then installed stripe. This seemed to work well as the tape did not have alot of waves or swags in it before we installed the stripes.

Don't know if we discovered America or not, but it seemed like a good way of doing it. Then, you have to match the door stripe with the scoop and the best way to do that is basically standing back away from it, adjusting, then marking where it should go, then installing.

Paul
PFSlim is offline   Reply With Quote
Old 01/24/2005, 12:42 PM   #6
Mosesatm
 
Mosesatm's Avatar
 

Location: Spokane, Washington
Joined: Jan 05
Posts: 7,351

Re:Stripe Experience

Just wondering if anyone has tried any of the new laser levels that are on the market. That would be slick if we could set it at the correct height and let it shoot a level line down the side of the car. Of couse it would be difficult to apply the stipe without blocking the laser but it would work to set points with tape or a marker that could be use as a guide.
Mosesatm is offline   Reply With Quote
Old 01/24/2005, 06:35 PM   #7
19HCS68
 
19HCS68's Avatar
 
FORD, the heartbreak of today's Chevrolet.

Joined: May 04
Posts: 110

Re:Stripe Experience

My black and decker laser level only shoots level horizontally. Mine would not work for this job. Just my half pennys worth.
19HCS68 is offline   Reply With Quote
Reply

  CaliforniaSpecial.com Forums > GT/CS and HCS Forums > GT/CS and HCS Discussions

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 08:55 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2017, vBulletin Solutions Inc.


This site created, owned and maintained by Jon Hanna - Copyright 1996-2011
All rights reserved. CaliforniaSpecial.com is not affiliated with Ford Motor Company

ShowCase vBulletin Plugins by Drive Thru Online, Inc.