CaliforniaSpecial.com -- Message Boards -- 1968 California Special Limited Edition Ford Mustang GT/CS
D I S C U S S I O N . F O R U M
COMMUNITY
1968 GT/CS & HCS
2007+ GT/CS
1966-1967 HCS

Vote!

Prev Previous Post   Next Post Next
Old 10/11/2006, 05:50 AM   #1
Mosesatm
 
Mosesatm's Avatar
 

Location: Spokane, Washington
Joined: Jan 05
Posts: 7,382

Pertronix and Vacuum

I just installed a Pertronix module and coil and now the car doesn't like to start as easily as it did. It used to start after one revolution, but now I must crank it 6, 7, or 8 times before it starts. Any ideas?

Also, does anyone have a diagram that shows where to run the vacuum lines to the distributor? On the forward port I have a line that comes from the forward vacuum distribution block but is also teed into the rear block. The rear port on the distributor runs straight to the forward block. With that setup the rear port is receiving much more vacuum at idle than the forward port, which seems correct to me since the vacuum should only kick in under acceleration.
Mosesatm is offline   Reply With Quote
 

  CaliforniaSpecial.com Forums > GT/CS and HCS Forums > GT/CS and HCS Discussions

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 03:34 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2017, vBulletin Solutions Inc.


This site created, owned and maintained by Jon Hanna - Copyright 1996-2011
All rights reserved. CaliforniaSpecial.com is not affiliated with Ford Motor Company

ShowCase vBulletin Plugins by Drive Thru Online, Inc.