CaliforniaSpecial.com -- Message Boards -- 1968 California Special Limited Edition Ford Mustang GT/CS
D I S C U S S I O N . F O R U M
COMMUNITY
1968 GT/CS & HCS
2007+ GT/CS
1966-1967 HCS

Vote!

Prev Previous Post   Next Post Next
Old 10/23/2005, 08:03 PM   #1
somethingspecial
 
somethingspecial's Avatar
 

Joined: Aug 05
Posts: 1,766

My Garage
Taillight restoration

:)Ladies and gentlemen, I have read many threads on dark tail lights. As many of you have read, I am going concorse on my 390-4 speed car, and I just completed the tail light restoration.
As discussed before, the tail lights become dark and non-reflective over the years as the chrome finish turns to black. I thought about sending the tail light castings out to be rechromed, but at what cost?
I have seen some discussion about tin foil as a quick fix, as I did years ago, but NOT now. I debated on the spray on chrome finish but thought this was cheesey.
Well, I was WRONG!!!!! I recently aquired a set of lights from a 65 T-bird as a spare set. One light was "Black", and the other was near mint chrome. I stripped the lights, removed the sockets, and wireing loom, cleaned the inside of the tail light bodies, and used "Rust-Oleum" bright coat, metallic finish Chrome, #7718. I painted the "Dark" body with the Rust-Oleum, and compared the two, the Rust-Oleum one was brighter than the original, and was very close in reflecticve properties.
For those who are concerned, the Resto went as follows:
The sockets tap out fairly easy, I used a small plastic hammer to gently tap the sockets out of the tail light body. Using 0000 steel wool, I cleaned any corrosion out of the tail light body, then wiped clean with a rag and Laquer thinner. Let dry and than apply several coats of Rust-oleum Chrome #7718. apply several thin coats as to prevent runs. Let dry between coats. Remember to allow at least 24 hours for full cure of the final coat before handling, and reassmebly.
The sockets can be cleaned using a 12 gauge Shotgun Cleaning brush. It fits good and will do a great job. I than used a good electical contact cleaning spray to clean any gunk out of the sockets and connectors. I used compressed air to blow any gunk out of the sockets and connectors. If you don't have access to an air compressor, You can use the canned air such as used on cameras.
Gently re-insert the sockets and install the new light bulbs. Don't forget to use Di-Electric grease on the bulbs.
I hope this helps you folks with a good restoration job. Good luck and keep the SPECIAL looking bright.
somethingspecial is offline   Reply With Quote
 

  CaliforniaSpecial.com Forums > GT/CS and HCS Forums > GT/CS and HCS Discussions

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 06:07 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2017, vBulletin Solutions Inc.


This site created, owned and maintained by Jon Hanna - Copyright 1996-2011
All rights reserved. CaliforniaSpecial.com is not affiliated with Ford Motor Company

ShowCase vBulletin Plugins by Drive Thru Online, Inc.