hatchdog
Well-known member
- Joined
- May 8, 2017
- Messages
- 164
Here's a strange one. The trunk key for my CS is the same blank less the square top (it is round as expected) as my ignition key. See picture for clarification, I marked the raised side on both with a black marker. Typically the trunk key with the round top would have the raised side opposite the ignition key. I went to my local Ace to have more keys cut and the only way they could cut my trunk key was to use a square top blank. Not the end of the world but this would make key selection difficult. I checked CJ's and all their blanks are the same as Ace. Any thoughts on this and any suggestions on how to resolve this? I searched this forum and found nothing. Thanks, Mike