franklinair
Well-known member
- Joined
- Mar 1, 2007
- Messages
- 4,744
Getting ready to install the 2 new side scoops. Installed the center stud.
The 2 front sheetmetal screw location is perplexing: It appears that the angle for the 2 screws through the front of the scoop is perpendicular to the quarter panel metal.
PMN's book, page 107 shows a drawing for the factory mounting of the scoops, but it doesn't make sense to me for the 2 screws' angle into the sheetmetal.
Anyone dealt with this?
Another curiosity- My Black CS scoops don't even have the recesses where these 2 screws are supposed to go.
Neil
The 2 front sheetmetal screw location is perplexing: It appears that the angle for the 2 screws through the front of the scoop is perpendicular to the quarter panel metal.
PMN's book, page 107 shows a drawing for the factory mounting of the scoops, but it doesn't make sense to me for the 2 screws' angle into the sheetmetal.
Anyone dealt with this?
Another curiosity- My Black CS scoops don't even have the recesses where these 2 screws are supposed to go.
Neil