Thread: [1968] Hood Scoop?
View Single Post
Old 05/01/2015, 06:15 PM   #9
stangfan's Avatar
GT/CS 8R01C150245

Location: Victoria, BC Canada
Joined: Jun 12
Posts: 1,501

My Garage
Originally Posted by robert campbell View Post
I have Ron Morris to move my engine back to clear the blower belt. But not down the 1/2 inch. Joe had a one inch plate milled down to 1/2 that he gave to me in a carb swap that works with my nozzle for the water methanol injection. Below is an early shot before the W/M injection, but I am still using this air cleaner. I actually had to "smash" the top a bit by tightening the nut down to get it under this hood.

This hood provides more clearance than a 68 Shelby hood by at least one inch.

As I remember you are installing a 351 Windsor based block in your car?

That 's quite the engine bay...

Steve Cracknell
stangfan is offline   Reply With Quote