Firstmustang
Active member
I started a minor rust remediation project under my battery tray and inside my passenger side wheel well. I discovered that rust had eaten through the sheet metal under the battery tray (see pic). I cut away the rusted metal and I'm planning on welding in a panel, however, I'm curious if anyone in the GT/CS world can point me to 1) the correct gauge of sheet metal to match the existing engine compartment sheet metal and 2) where would I buy this sheet metal (or can I just get garden variety correct gauge sheet metal from a metal supply store).
Also I can't seem to upload more than 1 photo on to my post...
Thanks,
Firstmustang
Also I can't seem to upload more than 1 photo on to my post...
Thanks,
Firstmustang