View Single Post
Old 01/20/2010, 03:19 PM   #3
murf104
 

Joined: Feb 03
Posts: 272

You are correct! It can be changed from the bottom and it is kind of a shi##y job. As Neil pointed out you must be careful to get the arm on top of the fuel pump ecentric when installing the pump. You can make it a bit easier by bumping the engine over until the ecentric is on the base circle as opposed to the high part - the pump will go in place much better if you can figure out how to do this. Things will also be better if it is not so cold that your fingers are stiff. Remove the P/S belt and swing the pump as far away from the engine as possible and it will give a bit more room but it is still tight. Good luck and rest assured that many of those pumps have been changed from the bottom. You may invent some new "prayers" while doing this task!
murf104 is offline   Reply With Quote